Before installing the DS4800 in a rack cabinet, you must install the rails and
rack-mounting hardware that come with your storage subsystem. The DS4800
requires an Electronic Industries Association (EIA) 310-D Type A 19-inch rack
cabinet. The distance between EIA rails, from the front to the rear of the rack
cabinet, is 60.96 cm (24 in.) minimum and 81.28 cm (32 in.) maximum. This rack
cabinet conforms to the EIA standard. Where you place the support rails in the rack
cabinet depends on where you intend to position the storage subsystem.
Figure 14 on page 36 shows the support rail assembly for the DS4800.
ds48021
DS4800
REAR
Rack Mounting
Template
0 U
2 U
3 U 3 U
2 U
1 U1 U
0 U
4 U
4 U
Rail assembly
(Rear left)
Rail assembly
(Rear right)
Printed in the U.S.A
Figure 13. DS4800 rear rack mounting template
Chapter 2. Installing the storage subsystem 35
To Next Page
Loading...
Need help?
General