4. Attach the DS4800 front bezel. Install the front bezel by aligning the pins on the
storage subsystem chassis with the spring-steel retainers on the cover, and then
press the cover toward the chassis until the pins snap into place. Figure 24
shows how to install the front bezel in the storage subsystem.
5. Continue with Chapter 3, “Cabling the storage subsystem,” on page 47.
RAID
controller A
Levers
in released position
RAID
controller B
ds48028
Figure 23. Replacing the controllers
ds48025
Figure 24. Removing the front bezel
46 IBM System Storage DS4800 Storage Subsystem: Installation, User’s, and Maintenance Guide
To Next Page
Loading...
Need help?
General