Chapter 20. SuSE Linux configuration guide 607
Draft Document for Review March 28, 2011 12:24 pm Linux Config.fm
Figure 20-4 Select Fstab Options
d. Select Device ID and press F10 to finish as shown in Figure 20-5
Figure 20-5 Select Device ID
Verify the boot order in MPT SAS BIOS to boot from the local hard disks using the
following procedure. If this setting are not correctly configured, the system will try to boot
from the logical drive instead of the local hard disk.
a. Reboot the server and press Ctrl-C at MPT SAS POST as shown in Figure 20-6 on
page 608
To Next Page
Loading...
