7. If you are instructed to return the flash device, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Replacing a USB embedded hypervisor flash device
To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page Safety and “Installation
guidelines” on page 30.
2. Align the USB flash device with the connector on the system board and push it
into the connector until it is firmly seated.
3. Slide the lockbar toward the riser-card assembly to the locked position until it
is seated firmly.
Chapter 6. Removing and replacing components 319
To Next Page
Loading...
