6. Gently slide the drive assembly into the drive bay until it clicks into place.
7. Install the filler panel.
8. If you are installing additional simple-swap drives, do so now.
9. Restart the server. Confirm that it starts correctly and recognizes the newly
installed devices, and make sure that no error LEDs are lit.
Note: If the server is configured for RAID operation using a ServeRAID
adapter, you might have to reconfigure your disk arrays after you install drives.
See the ServeRAID adapter documentation for additional information about
RAID operation and complete instructions for using the ServeRAID adapter.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 65.
Installing an optional optical drive
To install an optional optical drive, complete the following steps:
1. Read the safety information that begins on page Safety and “Installation
guidelines” on page 30.
2. Turn off the server (see “Turning off the server” on page 21) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Remove the top cover (see “Removing the server top cover” on page 33).
4. Locate the blue release tab on the rear of the drive bay; then, while you press
the tab, push the optical drive filler toward the front of the server.
42 System x3530 M4 Type 7160: Installation and Service Guide
To Next Page
Loading...
Need help?
General