IBM System x3530 M4 User Manual

8. Complete the additional steps in “Instructions for IBM Business Partners” on
page 24.
Replacing the air baffle
To install the air baffle, complete the following steps:
1. Read the safety information that begins on page Safety and “Installation
guidelines” on page 30.
2. Align the tabs on the sides of the air baffle with the slots on the fan cage and
lower the air baffle into the server.
Note: Make sure that no cable is pinched.
Replacing a PCI riser-card assembly
To replace a PCI riser-card assembly, complete the following steps:
1. Read the safety information that begins on page Safety and “Installation
guidelines” on page 30.
2. Install the adapter in the PCI riser-card assembly (see “Installing an adapter”
on page 46).
3. Align the PCI riser-card assembly with the PCIe slot connector on the system
board and align nailheads with the slots on the chassis; then, press down firmly
until the riser-card assembly is seated correctly in the connector on the system
board.
66 System x3530 M4 Type 7160: Installation and Service Guide

IBM System x3530 M4 Specifications

General

Brand	IBM
Model	System x3530 M4
Category	Server
Language	English