IBM System x3530 M4

7. If you are instructed to return the backplate assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Replacing the simple-swap SATA drive backplate assembly
To install the replacement simple-swap SATA drive and backplate assembly,
complete the following steps:
Note: The simple-swap SATA drive and backplate assembly must be installed in
the backplane slot closest to the information panel and the SATA drive must be
installed in the drive-bay closest to the information panel. The backplate assembly
cable connects to the CD/DVD-ROM drive connector on the system board.
1. Read the safety information that begins on page Safety and “Installation
guidelines” on page 30.
2. Align the tabs on the bottom of the drive backplate with the backplate slots on
the bottom of the backplane cage.
346 System x3530 M4 Type 7160: Installation and Service Guide