Replacing the front video connector
To replace the front video connector board, complete the following steps:
1. Read the safety information that begins on page Safety and “Installation
guidelines” on page 30.
2. Align the video connector with the slot on the server and install the two screws
to secure it to the server.
Note: Refer to the illustrations below for 2.5-inch and 3.5-inch hard disk drive
bays models respectively. Depending on your server model, align the video
connector from inside or outside the server.
340 System x3530 M4 Type 7160: Installation and Service Guide
To Next Page
Loading...
