To install the replacement system-board battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the
replacement battery.
2. Insert the new battery:
a. Position the battery so that the positive (+) symbol is facing you.
b. Place the battery into its socket, and press the battery press the battery
toward the housing until it clicks into place. Make sure that the battery clip
holds the battery securely.
3. Install PCI riser-card assembly 1 (see “Replacing a PCI riser-card assembly” on
page 329).
4. Install the cover (see “Replacing the server top cover” on page 67).
5. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Note: You must wait approximately 1 to 3 minutes after you connect the server
to a power source before the power-control button becomes active.
6. Start the Setup utility and reset the configuration.
Chapter 6. Removing and replacing components 335
To Next Page
Loading...
Need help?
General