4. Orient the safety cover as shown in the above illustration and align the screws
with the screw holes on the power interposer card. Tighten the screws to
secure the safety cover on the power interposer card.
5. Reconnect the power cables to the connectors on the system board and secure
the power cables with any cable clips on the chassis.
6. Reconnect the power cable from the RAID battery on the safety cover to the
ServeRAID adapter, if you have removed it.
7. Reinstall PCI riser-card assembly 2, if you removed it (see “Replacing a PCI
riser-card assembly” on page 66).
8. Reinstall the air baffle (see “Replacing the air baffle” on page 66).
9. Reinstall the cover (see “Replacing the server top cover” on page 67).
10. Reconnect the power cords and any cables that you removed.
11. Turn on the peripheral devices and the server.
Chapter 6. Removing and replacing components 343
To Next Page
Loading...
Need help?
General