CAUTION:
When laser products (such as CD-ROMs, DVD drives, fiber optic devices, or
transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
v Use of controls or adjustments or performance of procedures other than
those specified herein might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser
diode. Note the following.
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the beam.
7. Touch the static-protective package that contains the new optical drive to any
unpainted metal surface on the server; then, remove the optical drive from the
package and place it on a static-protective surface.
8. Attach the drive retention clip that you removed from the previous drive to the
side of the new drive.
9. Align the drive in the drive bay and slide the drive into the optical drive bay
until the drive clicks into place.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 65.
44 System x3530 M4 Type 7160: Installation and Service Guide
To Next Page
Need help?
General