Table 39. Configuration 6.
Note: Slot 1 is for standard low-profile ML2 adapter
Configuration 6
Configura
tion
Number of
micropro
cessors
installed
PCI riser-card assembly connector 1
on system board
PCI riser-card assembly connector 2 on system
board
Slot 1 Slot 2 Slot 3
v One ML2
slot
v Two
low-
profile
slots
One or two ML2
x1/x4/x8/x16
low-profile
Note: If only one
microprocessor is
installed, slot 2 cannot
be used
x1/x4/x8/x16
low-profile
Table 40. Configuration 7
Configuration 7
Configura
tion
Number of
micropro
cessors
installed
PCI riser-card assembly connector 1
on system board
PCI riser-card assembly connector 2 on system
board
Slot 1 Slot 2 Slot 3
v One
2.5-inch
hot-swap
rear hard
disk drive
kit
v One
low-
profile
slot
One or two X X
x1/x4/x8/x16
low-profile
Notes:
1. Always refer to the above configurations when installing a PCI riser-card
assembly. Do not install a PCI-riser card assembly that does not follow the
above configurations. For example, when the 2.5-inch hot-swap rear hard disk
drive kit is installed, only the PCI riser-card assembly with one x8 or x16
low-profile slot can be used for connector 2 on the system board.
The instructions in this section apply to any PCI adapter (for example, video
graphics adapters or network adapters).
To replace an adapter, complete the following steps:
Procedure
1. Read the safety information that begins on “Safety” on page vii and
“Installation guidelines” on page 122.
2. Turn off the server and peripheral devices and disconnect the power cords
and all external cables.
3. Remove the cover (see “Removing the cover” on page 126).
4. Follow the cabling instructions, if any come with the adapter. Route the
adapter cables before you install the adapter.
Chapter 5. Removing and replacing components 183
To Next Page
Loading...
