IBM x3100 M5 Type 5457 User Manual

Replacing the upper bezel
This procedure applies only to the 5U server model with hot-swap power supplies.
To install the upper bezel on the 5U server model with hot-swap power supplies,
complete the following steps.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2. Insert the two tabs on the right-side of the upper bezel into the corresponding
holes on the right side of the chassis.
3. Rotate the upper bezel to the left side of the chassis until the bezel clips are
aligned with the corresponding indentations on the left side of the chassis and
snap them into place.
4. Unlock and remove the side cover (see “Replacing the lower bezel” on page
190).
5. Remove the lower bezel (see “Replacing the side cover” on page 182).
6. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Bezel clips
Figure 91. Upper bezel installation for 5U server model with hot-swap power supplies
192 System x3100 M5 Type 5457: Installation and Service Guide

IBM x3100 M5 Type 5457 Specifications

General

Memory	Up to 32 GB
Form Factor	Tower
Chipset	Intel C222
Processor	Intel Xeon E3-1200 v3 series, Intel Core i3 series, Intel Pentium series
Memory Type	DDR3 ECC
Memory Slots	4 DIMM slots
RAID Support	RAID 0, 1, 10
Network	Dual Gigabit Ethernet
Storage Bays	4 x 3.5-inch
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Expansion Slots	1 PCIe 3.0 x8