4. Stand the server back up in its vertical position.
5. Install and lock the side cover (see “Replacing the side cover” on page 182).
6. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing the USB embedded hypervisor flash device
Use this information to remove the USB embedded hypervisor flash device.
To remove the USB hypervisor key on 4U server models with non-hot-swap power
supplies, complete the following steps. For the 5U server model with hot-swap
power supplies, please see the next sub-section.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2. Turn off the server and all peripheral devices; then, disconnect the power cords
and all external cables.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing
up.
Attention: Do not allow the server to fall over.
4. Remove the side cover (see “Removing the side cover” on page 38).
5. Remove the air baffle (see “Removing the air baffle” on page 39).
6. Locate the USB embedded hypervisor flash device connector on the system
board.
Fan power cable
Figure 130. 3.5" hard disk drive fan duct cable installation for 5U server model with hot-swap
power supplies
Chapter 6. Removing and replacing components 227
To Next Page
Loading...
Need help?
General