Replacing the bezel
This procedure applies only to 4U server models with non-hot-swap power
supplies.
To install the bezel on 4U server models with non-hot-swap power supplies,
complete the following steps.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2. Insert the three tabs on the bezel into the corresponding holes in the front of
the server.
3. Rotate the bezel to the server until it locks securely into place.
Figure 59. Bezel installation for 4U server model with non-hot-swap power supplies
Chapter 2. Installing optional devices 83
To Next Page
Loading...
Need help?
General