4. Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the server. Then, remove the new DIMM from the package.
5. Turn the DIMM so that the DIMM keys align correctly with the connector.
6. Insert the DIMM into the connector by aligning the edges of the DIMM with
the slots at the ends of the DIMM connector. Firmly press the DIMM straight
down into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the
DIMM is firmly seated in the connector. If there is a gap between the DIMM
and the retaining clips, the DIMM has not been correctly installed. Open the
retaining clips, remove the DIMM, and then reinsert it.
7. Stand the server back up in its vertical position.
8. Install and lock the side cover (see “Replacing the side cover” on page 182).
9. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing the system battery
Use this information to remove a system battery.
The following notes describe information that you must consider when replacing
the battery:
v IBM has designed this product with your safety in mind. The lithium battery
must be handled correctly to avoid possible danger. If you replace the battery,
you must adhere to the following instructions.
Note: In the U. S., call 1-800-IBM-4333 for information about battery disposal.
v If you replace the original lithium battery with a heavy-metal battery or a
battery with heavy-metal components, be aware of the following environmental
consideration. Batteries and accumulators that contain heavy metals must not be
disposed of with normal domestic waste. They will be taken back free of charge
by the manufacturer, distributor, or representative, to be recycled or disposed of
in a proper manner.
v To order replacement batteries, call 1-800-IBM-SERV within the United States,
and 1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and
Canada, call your support center or business partner.
Note: After you replace the battery, you must reconfigure the server and reset
the system date and time.
Statement 2
Figure 191. DIMM installation
Chapter 6. Removing and replacing components 279
To Next Page
Loading...
Need help?
General
