IBM x3100 M5 Type 5457 User Manual

5. Stand the server back up in its vertical position.
6. Install and lock the side cover (see “Replacing the side cover” on page 182).
7. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing and replacing Tier 1 CRUs
This section provides information for removing and replacing Tier 1 CRUs in the
server.
Replacement of Tier 1 CRUs is your responsibility. If IBM installs a Tier 1 CRU at
your request, you will be charged for the installation.
The illustrations in this document might differ slightly from your hardware.
Removing and installing internal drives
Use this information to remove and install internal drives.
The following figure shows the locations of the four 3.5" simple-swap hard disk
drive bays in the 4U server model with non-hot-swap power supplies.
1
2
Figure 105. Installing battery holder and bracket into chassis for 5U server model with
hot-swap power supplies
Chapter 6. Removing and replacing components 201

IBM x3100 M5 Type 5457 Specifications

General

Memory	Up to 32 GB
Form Factor	Tower
Chipset	Intel C222
Processor	Intel Xeon E3-1200 v3 series, Intel Core i3 series, Intel Pentium series
Memory Type	DDR3 ECC
Memory Slots	4 DIMM slots
RAID Support	RAID 0, 1, 10
Network	Dual Gigabit Ethernet
Storage Bays	4 x 3.5-inch
Operating System Support	Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware
Expansion Slots	1 PCIe 3.0 x8