Installing the hot-swap power supply
This procedure applies only to the 5U server model with hot-swap power supplies.
The following items describe the type of power supply that the server supports
and other information that you must consider when you install a power supply:
v To confirm that the server supports the power supply that you are installing, see
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us.
v The server comes standard with one 430-watt hot-swap power supply. The input
voltage is 110 V ac or 220 V ac auto-sensing.
v These power supplies are designed for parallel operation. In the event of a
power-supply failure, the redundant power supply continues to power the
system. The server supports a maximum of two power supplies.
v The server can run fully configured with one power supply. For redundancy
support, you must install the second hot-swap power supply.
Note: You cannot mix high-efficiency and non-high-efficiency power supplies in
the server.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
1
2
Statement 8
74 System x3100 M5 Type 5457: Installation and Service Guide
To Next Page
Loading...
Need help?
General
