5. Lock the side cover.
Connecting the cables
Use this information to connect the cables.
Attention: To prevent damage to equipment, connect the power cords last.
If the server cables and connector panel have color-coded connections, match the
color of the cable end with the color of the connector. For example, match a blue
cable end with a blue panel connector, a red cable end with a red connector, and so
on.
The following illustration shows the input/output (I/O) connectors on the rear of
the rear of 4U server models with non-hot-swap power supplies.
Key lock
Cover-release
latch
Figure 65. Side cover installation for 5U server model with hot-swap power supplies
Chapter 2. Installing optional devices 89
To Next Page
Loading...
Need help?
General