9. If you are instructed to return the power supply, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Replacing the non-hot-swap power supply
This procedure applies only to 4U server models with non-hot-swap power
supplies.
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any component
that has this label attached. There are no serviceable parts inside these
components. If you suspect a with one of these parts, contact a service
technician.
To install a non-hot-swap power supply on 4U server models with non-hot-swap
power supplies, complete the following steps.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
Figure 176. Non-hot-swap power supply removal for 4U server model with non-hot-swap
power supplies
Chapter 6. Removing and replacing components 261
To Next Page
Loading...
