The following illustration is for 5U server models with 3.5" hot swap hard
disk drives installed.
5. Press and hold the retaining tab on the side of the cage; then, rotate the drive
cage into the chassis until it locks into place.
Note: You may need to slightly lift up the cage in order to press and hold the
retaining tab.
Screws
Figure 156. 2.5" hot swap hard disk drive backplane screw installation for 5U server model
with hot-swap power supplies
Screws
Figure 157. 3.5" hot swap hard disk drive backplane screw installation for 5U server model
with hot-swap power supplies
Chapter 6. Removing and replacing components 245
To Next Page
Loading...
