CAUTION:
rThe power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current from
the device, ensure that all power cords are disconnected from the power source.
1
2
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following
label attached.
Hazardous voltage, current, and energy levels are present inside any component
that has this label attached. There are no serviceable parts inside these
components. If you suspect a with one of these parts, contact a service
technician.
Attention: During normal operation, each power-supply bay must contain either
a power supply or power-supply filler for proper cooling.
To install a hot-swap power supply on the 5U server model with hot-swap power
supplies, complete the following steps.
1. Read the safety information in “Safety” on page vii and “Installation
guidelines” on page 35.
2. Place the power supply into the bay guides.
3. Using the handle, push the power supply toward the front of the chassis until
it locks into place.
Chapter 6. Removing and replacing components 265
To Next Page
Loading...
Need help?
General