11-6
11
CONTROL COMMAND
q, w Memory channel number
0001–0199 : Memory channel 1 to 199
0200 : Programmed scan edge P1
0201 : Programmed scan edge P2
e Split setting
00: Split OFF
10: Split ON
When the program channel is selected, both settings
should be “00.”
r–i Operating frequency setting
r
XXXXX
ty
X
ui
XX XX
10 Hz digit: 0–9
1 Hz digit: 0–9
1 kHz digit: 0–9
100 Hz digit: 0–9
100 kHz digit: 0–9
10 kHz digit: 0–9
10 MHz digit: 0–5
1 MHz digit: 0–9
1000 MHz digit: 0
(Fixed)
100 MHz digit: 0
(Fixed)
o, !0 Operating mode setting
o Operating mode !0 Filter setting
00: LSB 03: CW 08: RTTY-R 01: Wide
01: USB 04: RTTY 02: Mid
02: AM 07: CW-R 03: Narrow
!1 Data mode setting
1 byte data (XX)
00: Data mode OFF
10: Data mode ON
NOTE:
• The same data as r–!1 are stored in r–!1.
• When the Split function is ON, the data of r–!1 is
used for transmit.
• Even if the Split function is OFF, enter the data into
r–!1 to match your transceiver. We recommend
that you set the same data as r–!1.
D Memory content setting
Command: 1A 00
X
eq、w r〜!1r〜io、!0 !1
X ……………… X XXXXXXXXX XXXX
To Next Page
Loading...
