6-3
6
FUNCTIONS FOR TRANSMIT
VOX function (Continued) ■
D VOX Set mode
Hold down q
VOX
for 1 second to enter the VOX Set
mode.
Rotate w [M-CH] to select “VoX GAIN.”
While speaking into the microphone at your normal e
voice level, rotate [DIAL] to the point where the
transceiver continuously transmits.
Rotate r [M-CH] to select “ANTI-Vox.”
During receive, rotate t [DIAL] to adjust the anti-
VOX gain to the point where the transceiver does
not switch to transmit due to received audio from
the speaker, or background noise.
Rotate y [M-CH] to select “VoX DELY.”
Rotate u [DIAL] to adjust the VOX delay for a conve-
nient interval before returning to receive.
Push i
VOX
to exit the VOX Set mode.
VOX Gain
50% (default)
[DIAL] [M-CH]
VOX
28
9
VOX GAIN
Adjusts the VOX gain for the VOX (Voice-Operated
Transmission) function. Higher values make the VOX
function more sensitive to your voice.
• Hold down
M-CL
for 1 second to return to the default
value.
ANTI-VOX
Adjusts the ANTI-VOX gain for the VOX (Voice-Oper-
ated Transmission) function.
Higher values make the
VOX function less sensitive to receiver output audio
from a speaker or headphones.
• Hold down
M-CL
for 1 second to return to the default
value.
VOX DELAY
This item adjusts the VOX (
Voice-Operated Transmis-
sion
) delay time. VOX Delay is the amount of time the
transmitter stays on after you stop speaking.
Adjust the delay time between 0 and 2.0 seconds, in
0.1 second steps.
• Hold down
M-CL
for 1 second to return to the default
value.
To Next Page
Loading...
