2-5
2
INSTALLATION AND CONNECTIONS
■ Power supply connections
Use a DC power supply with at least a 22 A capacity
when operating the transceiver with AC power. Refer
to the diagrams below.
CAUTION: Before connecting the DC power ca-
ble, check the following important items. Make sure:
• The switch is OFF.
• Output voltage of the power source is 12–15 V.
• DC power cable polarity is correct.
Red : Positive + terminal
Black : Negative _ terminal
CONNECTING THE PS-126 DC POWER SUPPLY
A DC power supplyAC outlet
AC cable
30 A fuses
Supplied DC power cable
13.8 V; at least 22 A
Black
_
Red
+
Transceiver
To DC power socket
To DC power socket
CAUTION: The rear panel will
become hot when continu-
ously operating the trans-
ceiver for long periods.
CAUTION: The rear panel will
become hot when continu-
ously operating the trans-
ceiver for long periods.
CONNECTING A NON-ICOM DC POWER SUPPLY
DC power cable
PS-126
AC outlet
AC cable
Transceiver
BE CAREFUL when disconnecting
the DC power cable because the
connector is tightly locked. Use a small
tool, such as a flat-bladed screwdriver,
to disengage the locking tab.
■ Connecting the DC Power Supply
To Next Page
Loading...
