7-4
7
MEMORY OPERATION
Memory programming (Continued) ■
D Programming in memory mode
Push q
V/M
➔
to select the Memory mode.
Rotate w [M-CH] to select the desired memory chan-
nel.
• If the RIT control indicator lights orange, push
M-CH/RIT
SET
.
(p. 7-2)
•
Memory channel contents appear in the display.
Lower channels
Higher channels
RIT control indicator
goes out
Rotate e [DIAL] to set the desired frequency, and
then push
MODE
to set the operating mode.
• To program a blank channel, directly enter the frequen-
cy with the keypad. (p. 3-6)
Hold down r
MW
for 1 second to write the displayed
frequency and operating mode into the memory
channel.
• 3 beeps sound when memory writing is completed.
[EXAMPLE]:
Programming 21.280 MHz/USB
into channel 18.
Memory mode
21.280 MHz/USB are now in channel 18.
[EXAMPLE]:
Programming 21.280 MHz/USB
into channel 18.
Memory mode
21.280 MHz/USB are now in channel 18.
[EXAMPLE]:
Programming 21.280 MHz/USB
into channel 18.
Memory mode
21.280 MHz/USB are now in channel 18.
Hold down
MW
to write
new data into channel 18.
Rotate [M-CH]
New frequency and mode entered
Current frequency and mode in channel 18.
[EXAMPLE]:
Programming 21.280 MHz/USB
into channel 18.
Memory mode
21.280 MHz/USB are now in channel 18.
To Next Page
Loading...
