Icom IC-7200

6-4
6
FUNCTIONS FOR TRANSMIT
■ Break-in function
The break-in function is used in the CW mode to auto-
matically switch the transceiver between transmit and
receive when keying. The IC-7200 is capable of full
break-in or semi break-in. Break-in operation is also
referred to as QSK.
D Semi break-in operation
During semi break-in operation, the transceiver im-
mediately transmits when keying, then automatical-
ly returns to receive after a pre-set delay time has
passed after you stop keying. This is similiar to the
VOX operation for voice.
Push q
MODE
to select CW or CW-R mode.
• Hold down
MODE
for 1 second to toggle between the
CW and CW-R modes.
Set the semi break-in mode to ON and the CW de- w
lay time in the Set mode. (See below)
“ e BK” appears on the LCD.
When using a paddle, set “KEY SPD” in the Quick
Set mode to adjust the keying speed. (p. 10-5)
[DIAL] [M-CH]
Appears
q Hold down
M-CH/RIT
SET
for 1 second twice to en-
ter the Set mode.
w Rotate [M-CH] to select “BK-IN” to select the
CW break-in mode.
e Rotate [DIAL] to select “SE.”
• FL : Full break-in
• SE : Semi break-in
• OF : Break-in OFF
r Rotate [M-CH] to select “BK-DELAY” to select
the CW delay time.
t Rotate [DIAL] to set the desired delay time.
• The delay time is selectable from 0.2 to 13.0
(dots) in 0.1 (dots) steps.
y Push
M-CH/RIT
SET
to exit the Set mode.
7.5 dots
Semi break-in operation
Previous view