4-9
4
RECEIVE AND TRANSMIT
Operating in the CW mode (Continued) ■
D Adjusting the CW side tone
When the transceiver is in receive, and the break-in
function is OFF, you can listen to the tone of your CW
signal without actually transmitting. (pp. 6-4, 6-5)
You can also use the CW sidetone to practice CW
sending, but be sure to turn OFF the Break-in func-
tion.
q
When the CW or CW-R mode is selected, hold down
M-CH/RIT
SET
for 1 second to enter the Quick Set mode.
Rotate w [M-CH] to select “SIDE LVL”, then rotate
[DIAL] to adjust the side tone level.
• Adjust the side tone level to between 0% and 100%, in
1% steps.
Push e
M-CH/RIT
SET
to exit the Quick Set mode.
D Setting Keying speed
The transceiver’s internal electronic keyer speed can
be set to between 6 and 60 words per minute (wpm).
q
When the CW or CW-R mode is selected, hold down
M-CH/RIT
SET
for 1 second to enter the Quick Set mode.
Rotate w [M-CH] to select “KEY SPD”, then rotate
[DIAL] to set the keying speed.
Push e
M-CH/RIT
SET
to exit the Quick Set mode.
To Next Page
Loading...
