Icom IC-7200

3-8
3
BASIC OPERATION
Frequency setting (Continued) ■
D Selecting the 1 Hz and 10 Hz tuning steps
When the Quick tuning step icon, “Z,” disappears, ro-
tating [DIAL] changes the frequency in increments of
1 or 10 Hz.
NOTE: The frequency is changed in 50 Hz steps
when the [UP]/[DN] switches of the microphone
are used for the frequency setting (when the Quick
tuning function is not selected, “Z” disappears.)
Hold down ➥
TS
for 1 second to toggle between the
1 Hz and 10 Hz step settings.
• When the 1 Hz step is selected, the 1 Hz digit appears in
the frequency display; when the 10 Hz step is selected, the
1 Hz digit disappears from the frequency display.
• Rotating [DIAL] changes the frequency in 1 Hz or
10 Hz tuning step.
[DIAL]
Hold down
for 1 second
Rotating [DIAL] changes the
frequency in 10 Hz steps.
Rotating [DIAL] changes the
frequency in 1 Hz steps.
TS
Appears
10 Hz tuning
1 Hz tuning
D
TS
switch flow chart
1 Hz tuning
10 Hz tuning
Quick step tuning (0.1 kHz –10 kHz)
Tuning step set mode
1 secondPush
TS
Push
TS
Push
TS
Hold down
Hold down
for 1 second
The Quick tuning
function is ON.
Appears
Appears
Previous view