Icom IC-7200

3-9
3
BASIC OPERATION
Frequency setting (Continued) ■
D Selecting the Auto tuning step
When rotating the tuning dial rapidly, the tuning speed
accelerates automatically if selected.
Hold down q
M-CH/RIT
SET
for 1 second twice to enter the
Set mode.
Rotate w [M-CH] to select “AUTo TS.”
Rotate e [DIAL] to select the desired tuning speed
between HI (High), Lo (Low) and oF (OFF).
• HI : Approximately 5 times faster when the tuning step
is set to 1 kHz or smaller steps; approximately 2
times faster when the tuning step is set to 5 kHz or
larger steps.
• Lo : Approximately 2 times faster
• oF : Auto tuning step is turned OFF
• Hold down
M-CL
for 1 second to select a default option
or value.
Push r
M-CH/RIT
SET
to exit the Set mode.
While operating in SSB data/CW/RTTY, the ¼ tuning
function can be used for critical tuning. Dial sensitivity
is reduced to ¼ of normal when the ¼ function is in
use.
Hold down q
M-CH/RIT
SET
for 1 second twice to enter the
Set mode.
Rotate w [M-CH] to select “DIAL ¼.”
Rotate e [DIAL] to select the ¼ tuning function ON
or OFF.
• Hold down
M-CL
for 1 second to select a default option
or value.
Push r
M-CH/RIT
SET
to exit the Set mode.
NOTE: This function is only selectable when the
Quick tuning function is OFF. (p. 3-7)
D Using the ¼ tuning function (SSB data/CW/RTTY only)
[DIAL] [M-CH]
When “HI” is selected (default)
When “OFF” is selected (default)
[DIAL] [M-CH]
Previous view