6-7
6
FUNCTIONS FOR TRANSMIT
D Setting the compression level
• Setting the microphone gain
Push q
MODE
to select SSB mode.
• Hold down
MODE
for 1 second to toggle between the
USB and LSB modes.
Push w
COMP
to turn OFF the speech compressor
function, if it is ON.
• “ ” disappears.
Hold down e
ANF
METER
for 1 second several times to se-
lect ALC meter.
• “ALC” appears.
Adjust the MIC gain r
in the Quick Set mode.
(See
below)
• Setting the compression level
Hold down q
ANF
METER
for 1 second several times to se-
lect ALC meter.
• “ALC” appears.
w Hold down
COMP
for 1 second to enter the speech
compression level Set mode.
• The speech compressor function is set to ON and
“
” appears.
You can enter the speech compression level Set
mode before selecting ALC meter in step q.
While transmitting, speak at a normal voice level e
and rotate [DIAL] to adjust the speech compres-
sion level so that the ALC meter reads within the
ALC zone, whether you speak softly or loudly.
• Adjust the level to between 0 and 10, in one unit steps.
• Hold down
M-CL
for 1 second to return to the default
value.
r
Push
COMP
to exit the speech compression level
Set mode.
Push t
COMP
to turn the speech compressor func-
tion OFF when it is not necessary.
• “ ” disappears.
NOTE: If the ALC meter peaks above the ALC
zone, your voice may be distorted.
q Hold down
M-CH/RIT
SET
for 1 second to enter the
Quick Set mode.
w Rotate [M-CH] to select “MIC GAIN” to set the
microphone gain.
e
While transmitting, speak at a normal voice lev-
el and rotate [DIAL] to adjust the microphone
gain so that the ALC meter reads within the
ALC zone, whether you speak softly or loudly.
• Hold down
M-CL
for 1 second to return to the de-
fault value.
r Push
M-CH/RIT
SET
to exit the Quick Set mode.
Speech compressor ■
Level 5 (default)
ALC zone
To Next Page
Loading...
