Icom IC-7200

4-5
4
RECEIVE AND TRANSMIT
Connect a paddle, straight key or external electron- q
ic keyer as described on page 2-8.
Hold down w
F-INP ENT
BAND
for 1 second, then push a
band key to select the desired band.
Push e
MODE
to select the CW mode.
 •Holddown
MODE
for 1 second to toggle between the
CW and CW-R modes.
Rotate r [DIAL] to tune in a desired signal.
 •TheS-meterdisplaysthereceivedsignalstrengthwhen
asignalisreceived.
Rotate the t [AF] control to set the audio to a com-
fortablelisteninglevel.
Set CW break-in mode and the CW delay time in y
the Set mode.
Key to transmit, using the paddle, straight key or u
external electronic keyer to send your CW signals.
 •“ ” appears.
 •ThePometerdisplaysthetransmitoutputpower.
Stopkeyingtoreceive. i
Band keys
[DIAL]
[AF]
“CW” or “CW-R” appears.
Appears while transmitting.
[M-CH]
Appears when semi break-in is selected.
Semi break-in (default: OFF)
7.5 dots (default)
q Hold down
M-CH/RIT
SET
for 1 second twice to enter
the Set mode.
w Rotate [M-CH]toselect“BK-IN” to set the CW
break-in mode.
e Rotate [DIAL] to select full break-in, semi
break-in or OFF.
 •FL :fullbreak-in
 •SE :semibreak-in
 •OF :break-inOFF
r Rotate [M-CH] to select “BK-DELAY” to se-
lect the CW delay time when the semi break-in
mode is selected in step e.
t Rotate [DIAL] to set the desired delay time.
y Continue to set the keyer settings in the Set
mode, if necessary. (p. 10-15)
u Push
M-CH/RIT
SET
to exit the Set mode.
“CW” or “CW-R” appears.
Appears when semi break-in is selected.
Appears while transmitting.
Set mode
■ Operating in the CW mode
Previous view