Chapter 4
Autotesting
4-9
5. When the Autotest is
completed, an overall result of
pass or fail is displayed at the
top right of the test information
columns.
Results for individual tests are
displayed opposite each test
name.
6. To begin the next Autotest, press Autotest
.
7. If results from the current test have not been printed, or you did not have
AutoSave enabled in the Autotest Preference screen, you will be prompted to
discard or save the current test results before the next Autotest will run.
Note: The tester also performs real time Analyze testing that enables you to troubleshoot
problem areas. If Autotest results indicate a failure, refer to Chapter 5, Analyze
Testing.
To Next Page
Loading...
Need help?
General