Chapter 1
Quick Start
1-8
Chapter 3 Calibration, Configuration, and Special Operations
This chapter describes the test adapters and reference patchcords as well as the
use of the Tone Generator and Digital Talkset. It explains the procedures for
calibration, configuration, cable identification, selecting cable types and custom
cable settings. The last section depicts the useful effects of performing Time
Domain Reflectometer tests.
Chapter 4 Autotesting
This chapter describes the Autotest function and provides instructions for setting
up test preferences. This chapter also describes individual tests that run during an
Autotest and provides instructions for viewing and interpreting Autotest results.
Chapter 5 Analyze Testing
This chapter describes the Analyze test function and provides instructions for
setting up test preferences and running an Analyze test. This chapter also provides
instructions for viewing and interpreting test results.
Chapter 6 Using LANTEK REPORTER
This chapter describes how to upload test data from the LANTEK tester to a PC
or laptop and how to organize and print the test data.
Chapter 7 Cable Testing Fundamentals
This chapter describes physical and electrical characteristics of cables, test
descriptions, test storage and data management procedures. This chapter also
describes how to set up different cabling tests, what to do when tests fail and
typical causes of test failure.
To Next Page
Loading...
Need help?
General