4-1
Chapter 4
Autotesting
Contents
• Autotest Overview
• Autotest Preferences
• Running Autotest
• Interpreting Autotest Results
• Autotest Graphs
Autotest Overview
Autotest is the easiest and quickest way to measure and verify your cable
installation. When the Autotest key is pressed, the LANTEK tester automatically
performs a series of pre-programmed tests. These test suites are pre-determined
based on either adopted or proposed standards as well as specific parameters.
After all tests have been completed, the tester displays a single overall pass/fail
result and individual test pass/fail results.
Autotests are performed with the Display Handset (DH) and Remote Handset
(RH) connected at opposite ends of the cable under test.
Test Suites
The tests run during an Autotest depend on the cable type selected (refer to
Chapter 3, Changing a Cable Type).
• Autotest can be preset to automatically save test results immediately following
each suite of tests, or results can be saved and printed manually. To preset
these functions, see Autotest Preferences in this chapter.
To Next Page
Loading...
Need help?
General