Chapter 3
Calibration, Configuration, and Special Operations
3-51
Storing, Retrieving, and Deleting TDR Results
Storing a Graph
The TDR results can be stored in the Current Job.
1. Press the Up/Down Arrow keys to select the desired cable pair graph.
2. Select . The Save Test screen appears.
3. The test name is automatically assigned. If a different name is desired, use the
Delete key to change the highlighted character(s).
Note: The default Save As… name is derived from the cable name entered into the
Cable ID screen, or from the previous saved name.
4. When you have entered the name, press Enter to accept the changes and
return to the ready screen.
Retrieving or Deleting a Graph
For detailed instructions regarding retrieving or deleting stored TDR results, refer
to Chapter 4, Viewing or Deleting Stored Autotest Results.
To Next Page
Loading...
Need help?
General