Chapter 6
Using LANTEK REPORTER
6-3
Installation Procedure
The LANTEK Reporter software is installed using the standard Windows 95, 98,
ME, XP, 2000, NT up to SP6 program installer.
1. Insert the LANTEK Reporter CD-ROM.
2. Click on the Start button, and then click Run.
3. Type, d:\ setup
Note: If your CD-ROM drive is not the “d” drive, replace “d” with the correct drive
letter.
4. Follow the instructions on your screen.
Note: Install the LANTEK Reporting System in the default directory, c:\…\ LANTEK
Reporter. An empty database will be created in c:\…\ LANTEK Reporter \db.
Figure 6-1: Typical Installation Window
To Next Page
Loading...
Need help?
General