REMOTE OPERATION
5-28 46882/439
BLANK?
Prepares message containing information on the display blanking setting in the
following format:
:BLANK:<state>
where: <state> is program mnemonic indicating whether the blanking is ON
or OFF
Example:
BLANK:OFF
CONTRAST
Sets the LCD contrast, over a scale of 0 to 31.
Data type :
Decimal Numeric Program Data
Allowed suffices :
none
Default suffix :
none
Example:
CONTRAST 16
CONTRAST?
Prepares message containing information on LCD contrast setting in the
following format:
:CONTRAST <nr1>
Example:
:CONTRAST 23
BRIGHTNESS
Sets the LCD brightness to DIM, MEDIUM or BRIGHT.
Data type :
Character Program Data
Allowed suffices :
None
Default suffix :
None
Example:
BRIGHTNESS MEDIUM
BRIGHTNESS?
Prepares message containing information on LCD brightness setting in the
following format:
:BRIGHTNESS <brightness>
where: <brightness> is character program data indicating the brightness
level.
Example:
:BRIGHTNESS BRIGHT
ELAPSED
:RESET
Reset elapsed operating hours to zero
Data type :
None
Allowed suffices :
None
Default suffix :
None
Example:
ELAPSED:RESET
ELAPSED?
Prepares message containing information on elapsed operating hours since last
reset. Fractional part is in 15 minute intervals (0.25, 0.50, 0.75). Format is as
follows:
<nr2>
Example:
454.50
OPER?
Prepares message containing information on total operating hours. Fractional
part is in 15 minute intervals (0.25, 0.50, 0.75). Format is as follows::
<nr2>
Example:
1453.00
POWUP
[not used alone]
To Next Page
Loading...