LOCAL OPERATION
3-46 46882/439
Storing data
Select the memory store function as follows:
(1) Press the [MEM] hard key and then, if necessary, press the [Store/Recall] soft key to display
the Memory Store Menu shown in Fig. 3-43 below.
B3482
Fig. 3-43 Memory store menu
(2) To store data, press the [Full Store], [Carrier Store] or [RAM Store] key for the type of store
required, then enter the store location via the numerical key pad and terminate with
[ENTER].
Note that memory erasure requires unlocking to Level 2 (see ‘Protection locking and unlocking’
on page 3-38).
Memory protection
Memory stores may be protected against accidental overwriting of the contents.
Memory protection summary
(1) To see which store locations are protected (or unprotected), press the [Memory Protect] key.
If the instrument is in the protection locked state, the Memory Write Protection Summary
shown in Fig. 3-44 below is displayed. Otherwise Fig. 3-45 below is shown.
B3484
Fig. 3-44 Memory write protection summary
(2) From the summary, select the type of memory stores to be displayed by selecting between
[Full Stores], [Carrier Stores] and [RAM Stores]. An unprotected store is indicated by a
dash (−), a protected store is indicated by the letter p.
To Next Page
Loading...
General