46882/439 3-31
Utilities
Utility menu selection
Pressing the [UTIL] key gains access to the utilities options from two primary menus, Utilities
Selection Menu 1 and Utilities Selection Menu 2. When a selection is made from either of these
menus and [UTIL] is subsequently pressed, the primary menu is re-displayed. However, if instead
a selection is made and then one of the other hard keys − for example, [MEM] − is pressed,
pressing [UTIL] subsequently once return to the sub-menu, pressing it again returns to the primary
menu. This provides an operating short-cut in that it allows you to re-access a sub-menu without
first having to go again through the primary menu.
Selection menu 1
The display for Utilities Selection Menu 1 is shown in Fig. 3-21 below.
B3453
Fig. 3-21 Utilities selection menu 1
To obtain Utilities Selection Menu 2 from the menu, select [Utils Menu 2].
Display adjustment (menu 1)
You can set the display contrast and brightness to suit your individual preferences using this
utility. The setting can then be saved for automatic recall whenever the instrument is switched on.
Proceed as follows:
(1) Select [Display Adjust] to call up the Display Adjustment Utility shown in Fig. 3-22 below.
To Next Page
Loading...
General