SWEEP
46882/439 3-29
(14) Whilst the sweep is paused you can adjust the frequency by selecting [Sweep Freq] then
using the control knob to look at a particular frequency of interest. Pressing [Transfer]
followed by [Continue Sweep] causes the sweep to continue from your adjusted frequency.
Otherwise simply pressing [Continue Sweep] restarts the sweep from where it was paused.
Pressing [Reset Sweep] discontinues the sweep and resets it to the start frequency.
(15) At the end of a single sweep, the stop frequency is shown and the key function changes to
[Start Sweep] with SWEEP COMPLETE displayed. For continuous sweep, the sweep
automatically recommences from the start frequency.
(16) To change the sweep mode, press the [Sweep Mode] key which returns you to the Carrier
Sweep Mode menu.
To Next Page
Loading...