Ikegami FA-97A - Page 11

vii
HDK-99 1803 VER1 (E)
SAFETY PRECAUTIONS
Regarding the Fiber Connector and the Fiber Optic Cable
Take care for the following:
- When disconnecting the ber optic cable from the camera or from the CCU, always hold the ber
connector (plug) and not the cable.
- Do not crush the cable.
- Since there can be various obstacles (such as a corner of a building, glass, rough ground surface)
in places where the cable is connected, do not drag the cable without winding.
- Turn off the power before removing the ber optic cable.
- The allowable radius of curvature of ber optic cables is approximately six times of the outer
diameter of cables (approx. 60 mm for a φ9.2mm-wide cable). Do not force to wind less than
specied. Forcible winding can break ber leads within the cable.
Fiber Optic Cable
Radius
Approx. 60mm
- When connecting a ber optic cable to a ber connector, anchor the ber optic cable with a cable
clamp.
Optical Fiber Cable
CAMERA CABLE Clamp
CAMERA CABLE Clamp
(optional)