IMO SD1 Series - Page 72

SD1 Series Inverters Function Parameters
-67-
Function
code
Name Description Default Modify
15: Value 2 set through Modbus communication
16: Value 1 set through PROFIBUS/CANopen/
DeviceNet communication
17: Value 2 set through PROFIBUS/CANopen/
DeviceNet communication
18: Value 1 set through Ethernet communication
19: Value 2 set through Ethernet communication
20: High-speed pulse HDIB input value
21: Value 1 set through EtherCAT/PROFINET
communication
22: Torque current (relative to 3 times the rated
motor current)
23: Ramp reference frequency
24: Set frequency (bipolar)
25: Ramp reference frequency (bipolar)
26: Running speed (bipolar)
27: Value 2 set through EtherCAT/PROFINET
communication
28: C_AO1 from PLC (P27.00 must be 1.)
29: C_AO2 from PLC (P27.00 must be 1.)
30: Running speed (relative to twice
the motor
synchronous rotational speed)
31~47: Reserved variable
P06.17
Lower limit of
AO1 output
The above function codes define the relative
relation between the output value and analog
output. When the output value exceeds the
range of set maximum or minimum output, it will
count according to the low-limit or upper-limit
output.
When the analog output is current output, 1mA
equals to 0.5V.
In different cases, the corresponding analog
output of 100% of the output value is different.
R
efer to each application for detailed
information.
0.0%
○
P06.18
Corresponding
AO1 output to
the lower limit
0.00V
○
P06.19
Upper limit of
AO1 output
100.0%
○
P06.20
C
orresponding
AO1 output of
the upper limit
10.00V
○
P06.21
AO1 output
filter time
0.000s
○
P06.22
Lower limit of
AO2 output
0.0%
○