To Next Page

To Previous Page

14 Model 10000 30-foot Parts & Specifications Manual Part # 99905185

Greasing Instructions

Different lubricants are required for different sections of your crane. Contact your lubricant

supplier for specific product information. Follow the grease and lubricant specifications and

intervals listed in this manual for best results.

Crane grease zerks must be greased on a weekly basis during normal operating conditions.

Under severe operating conditions the zerks must be greased more frequently. Each grease

zerk is marked with a decal, “Grease Weekly”, as shown. Rotate the worm gear bearing when

greasing the worm gear bearing grease zerks.

Crane worm gear bearing teeth must be lubricated weekly with Molub-Alloy 882 Heavy or

equivalent, applied with a grease gun or brush. Cover all teeth with grease and leave no

exposed metal surfaces showing.

Weekly, remove cover and lubricate with

MOLUB-ALLOY 882 HEAVY

open-gear compound while rotating crane.

MOLUB-ALLO Y is a registered trademark of

Castrol Industrial PLD Downers Grove, I L 1-800-621-6221

70392399

Questions and Answers:

Need help?

Do you have a question about the IMT 10000 and is the answer not in the manual?

IMT 10000 Specifications

General