8 - 17
PN 074-519-P1C
3000 Micro GC Operating Manual
2 Remove the small metal plate covering the O-rings on the upper gang block.
See Figure 8-19.
Figure 8-19 Protective plate on upper gang block
3 Inspect the GC module mounting flange fitting to verify all new O-rings on the
replacement GC module are undamaged and seated properly. See Figure
8-20.
Figure 8-20 Inspect the new O-rings
Retaining screw
Metal plate covering O-rings and
upper gang block
Mounting flange
Verify O-ring placement
Gang block, upper half
To Next Page
Loading...
