5 - 16
PN 074-519-P1C
3000 Micro GC Operating Manual
12 Remove the blue cap from the 1/8 in. NPT male input fitting and install a
user-provided 1/8 in. female NPT fitting and sample line. See Figure 5-20.
Figure 5-20 Installing the sample line
If a hazardous sample is used, the sample exhaust must
be vented to a fume hood or other designated area for
hazardous waste disposal.
13 Connect a vent line to the vent fitting using standard 1/8 in. fittings. Run the
exhaust to a fume hood or other designated area for hazardous waste disposal.
Figure 5-21 Installing the vent tubing
PN G2816A
Tighten
Tighten
Flow adjustment knob
Remove blue cap
from NPT fitting and
install sample line
Install vent tube here
PN G2816A
To Next Page
Loading...
