28 Intel Server Board SE7501BR2 Product Guide
Intrusion Switch Monitoring
To help prevent unauthorized entry or use of the server, the Intel Server Management software
monitors the chassis intrusion switch if one is installed in the chassis. Opening an access cover will
transmit an alarm signal to the server board, where BMC firmware and server management
software process the signal. The system can be configured through ISM to respond to an intrusion
a number of ways, including powering down or locking the keyboard.
Floppy Write Protection
When selected in Setup, the option for floppy write protection prevents writes to the floppy disk
while the system is in secure mode. Floppy write protection is in effect only while the system is in
secure mode. When not in secure mode, write protection is disabled and the floppy diskette drive
operates normally.
Fixed Disk Boot Sector Write Protect
The fixed disk write-protect switch is set to “Write Protect” to prevent writes to the fixed IDE disk
boot sector. This feature works only with IDE drives and only the boot sector is write protected.
Power Switch Mask
The power switch mask enables and disables the power button feature. If it set to masked, the
system power cannot be turned off with the power button after booting the operating system.
Termination is also disabled. Termination is a feature that terminates system power when the
power switch is held down for more than four seconds.
To Next Page
Loading...
Need help?
General
