Figure E-26. Bolster Plate, M3 Captive Nut Collar
A A
13
4
5678
B
C
D
A
123
4
5678
B
C
D
A
A
B
2200 MISSION COLLEGE BLVD.
P.O. BOX 58119
SANTA CLARA, CA 95052-8119
R
.2 A B
.2 B
.2 B
5.7 0.05
6.5 0.05
1.9±0.05
0.4±0.03
(4.38)
5
H19329 1 07
DWG. NO SHT. REV
SHEET 1 OF 1
DO NOT SCALE DRAWING
SCALE: 21:1
07H19329D
REV
DRAWING NUMBER
SIZE
SOCKET P
M3 BOLSTER CAPTIVE NUT COLLAR
TITLE
DEPARTMENT
SEE NOTESSEE NOTES
FINISHMATERIAL
-
DATEAPPROVED BY
-
9/11/15
DATECHECKED BY
9/10/2013
DATEDRAWN BY
8/8/2013
DATEDESIGNED BY
DIMENSIONS ARE IN MILLIMETERS
THIRD ANGLE PROJECTION
PARTS LIST
DESCRIPTIONPART NUMBER
ITEM NO
QTY
SOCKET P M3 BOLSTER CAPTIVE NUT COLLARH19329-003TOP
REVISION HISTORY
ZONE REV DESCRIPTION DATE APPR
- 01 TOOLING RELEASE 9/10/2013
02 UPDATED NOTES 3/27/15
03
1. ROLLED THE PART NUMBER FROM -001 TO -002.
2. CHANGED GEOMETRY
4/1/5/15
04 1. ADDED NOTE 7 TO CALL-OUT CRITICAL TO FUNCTION DIMENSIONS. 4/23/15
05
1. ADDED DATUMS A AND B AND FEATURE CONTROL FRAME TO DIMENSION.
2. CHANGED INNER DIAMETER FROM 4.42MM TO A REFERENCE
DIMENSION 4.38MM.
3. ROLLED PART NUMBER FROM -002 TO -003.
5/6/15
06 1. UPDATED DIMENSIONING SCHEME 9/11/15
B6
D7
07
1. ADDED CTF DIMENSION TO COLLAR DIAMETER.
2. ADDED DATUMS A AND B TO THE FEATURE CONTROL FRAME IN NOTE 2.
7/11/16
NOTES UNLESS OTHERWISE SPECIFIED
1. REFERENCE DOCUMENTS
ASME Y14.5M - 2009 - STANDARD DIMENSION AND TOLERANCES
UL1439 - UL SHARP EDGE TESTING
2. FEATURES NOT SPECIFIED ON DRAWING SHALL BE CONTROLLED BY 3D CAD DATABASE.
FOR FEATURES NOT EXPLICITLY TOLERANCED:
(BASIC DIMENSIONS FROM THE 3D CAD MODEL)
3. MATERIAL:
-ANSI 1215 CARBON STEEL OR EQUIVALENT
-CRITICAL MECHANICAL PROPERTIES: 415 MPa MIN YIELD STRENGTH
-MAY USE INTEL ENGINEERING APPROVED EQUIVALENT
4. FINISH:
-2 MICROMETER MIN ELECTROLYTIC NICKEL PLATING
-PROCESS TEST 168 HRS 85 DEGREES C / 85% HUMIDITY WITH NO VISIBLE
CORROSION, AFTER MATING WITH PRESS FIT NUT INTERFACE
5 FEATURE DEFINED BY VENDOR - FOR INTERFERENCE FIT WITH PART H19328-002
FEATURE MAY BE MODIFIED WITH INTEL ENGINEERING APPROVAL, IN ORDER TO MEET
MINIMUM 50LBF SEPARATION FORCE FOR NUT/COLLAR PRESS FIT INTERFACE
6. SHARP CORNERS MUST BE CHAMFERED, OR ROUNDED TO 0.1MM RADIUS MAX.
7. DIMENSIONS MARKED ARE CRITICAL TO FUNCTION DIMENSIONS (CTF).
SECTION A-A
C
C
C
.
To Next Page
Loading...
Need help?
General
