Intellian v130 User Manual

109
REMOTE WEB ACCESS
WARNING: Enter Save & Reboot page and click on “Save & Reboot” button after
completing the modication of Ethernet-to-Serial’s settings. Without doing so, the
modied settings will be lost.
Ethernet-to-Serial Settings
Network Setting
No. Item Description
1
Network Setting Modify ACU’s Internal IP address.
2
Network Conguration
Modify ACU’s Internal IP address and press Submit
button. Go to “Save & Reboot” page and press Save &
Reboot button to validate the changes.
- IP Address: Factory default
(Primary: 192.168.0.223)/(Secondary: 10.10.1.1)
- Subnet Mask: Factory default (255.255.255.0)
- Gateway (modem IP): Factory default (192.168.0.254)
3
Network Service
Conguration
Install the PortView software to use this function.
Setup the IP address and socket number to the PC
installed with PortView software.
PortView function will not be activated if the IP address is
set to 0.0.0.0.
4
Browser Conguration
Modify browser refresh rate and refresh disable time.
If the check box of Refresh Disable Time is enabled,
then Refresh Disable Time function will be activated and
system will keep monitoring all activities regardless of
time-out.
1
2
3
4

Intellian v130 Specifications

General

Brand	Intellian
Model	v130
Category	Antenna
Language	English