Intellian v130 User Manual

v130 – Marine Satellite Communication System
78
• Enable the Usage of External Lock & TX Mute
- Connect a RJ45 cable from the Ethernet connector on the ACU to the modem or
connect a 9 pin serial cable from the RS232/422 connector on the ACU to the
modem.
- Select a proper data communication port (RS232/422/Ethernet) to interface with
a modem.
- Select a proper communication protocol (I/O Console/OpenAMIP/Serial GPS) to
interface with a modem.
- Enable / disable the usage of TX MUTE function.
- TX Mute is a transmit inhibit output from the ACU to disable/mute the modem
transmit through a 5 V (HIGH) or 0 V (LOW) current whenever the antenna is
blocked, searching, or is mis-pointed 0.5 degrees from peak satellite position.
This item will only be activated when the modem protocol is set as I/O Console.
- Enable/disable the usage of External Lock function. This function will only be
activated when the modem protocol is set as I/O Console.
- Modem Lock is referred that modem lock output from the modem provides a logic
input through a 5 V (HIGH) or 0 V (LOW). current to the ACU to identify when it is
on the correct satellite. This item will only be activated when the modem protocol
is set as I/O Console.
• Select GPS Out Sentence Type
- Select GPS OUT SENTENCE type (GPGLL/GPGGA/Simple GPGGA)
• Use Mediator
-Enable the usage of Mediator if the antenna is connected to the Intellian
Dual VSAT Mediator.
Disable this function if there is no Mediator connected to the ACU.
Improper setting of this parameter will cause your ACU’s modem inter
face working incorrectly.
• Select Modem
-Select a proper data communication port and protocol on the ACU to interface
with the satellite modem. The settings related to the modem interface will be set
automatically once the modem type is selected. If USER SETTING is selected, a
separate input of modem port and modem protocol is required.

Intellian v130 Specifications

General

Brand	Intellian
Model	v130
Category	Antenna
Language	English